02 / Process
TIG welding in Utah for precise, visible joints
TIG is the slow, careful process in our shop. The welder holds a torch with a tungsten electrode in one hand and feeds filler rod with the other, controlling heat with a foot pedal. It takes longer than MIG, but it gives the most control over the puddle, which is what thin material, aluminum and visible joints need.

What TIG welding looks like in our shop
We reach for TIG on enclosure corners, thin brackets, aluminum covers and parts that someone will look at every day. The bead comes out narrow and neat, with very little spatter, and heat can be eased off right where the edge gets thin.
TIG also gives us a way to join small parts without overheating them. A tab on a thin panel, a corner on a sheet metal box or a short seam on a finished part can be welded with less distortion than a hotter, faster process would cause.
How we run a TIG job
- 01
Clean is everything
TIG does not forgive dirt. We remove oil, oxide and mill scale from the joint area and keep a separate brush for aluminum so steel dust never gets into it.
- 02
Tight fit-up
Gaps make TIG slow and uneven, so parts are cut and fitted closely and tacked in several places before the main weld.
- 03
Heat where it is needed
The foot pedal lets the welder add heat at a thick corner and back off at a thin edge. On long seams we stitch and move around to keep the part flat.
- 04
Finish to the drawing
Most TIG welds need little more than a wipe. If a face should be blended or brushed, we do it and note it in the quote.
What to send for a quote
Fill in the form, then email these to [email protected]. The more we see, the fewer questions we need to ask.
Request a quote- Drawing or photos of the part and the joints
- Material, alloy if known, and thickness
- Which welds are visible and how they should look
- Quantity and when you need the parts
- Any coating or anodizing planned after welding
Questions
TIG welding questions
Answers we give most often about this kind of work.
Is TIG stronger than MIG?
Not by itself. A good weld in either process fuses the joint properly. TIG is chosen for control and appearance on thin or visible joints, not because it is always stronger.
Can you TIG weld aluminum?
Yes. Aluminum is one of the main reasons we run TIG. See our aluminum welding page for how we prepare it.
Why does TIG take longer?
The welder controls the heat and filler by hand and moves more slowly. That is the trade for a neater bead and less heat in the part.
Can TIG welds be left as is on a visible part?
Often they can. A clean TIG bead has an even ripple that many customers like to keep. If you want it blended flat, tell us.
Do you TIG weld stainless steel?
Yes, for small stainless parts and enclosures. We keep stainless clean and separate from carbon steel tools while it is in the shop.
Send us the part for TIG welding
Form first, then the drawing, sketch or photos by email. We review and reply with a written quote.

