03 / Material
Steel welding in Utah for equipment parts and frames
Mild steel is most of what we weld. It is easy to cut, easy to fit and welds well by either MIG or TIG, which is why it shows up in so many equipment parts, guards and frames. This page is about the material: how we handle it, what we make from it and how we choose the process for each part.

What steel welding looks like in our shop
Steel parts arrive in every form: flat bar, plate, angle, square and rectangular tube, sheet, and sometimes a mix in one assembly. We sort the stock by thickness, plan which welds can be MIG and which should be TIG, and set up the jig or table so the parts come out square.
Steel moves as it heats and cools. A frame welded all on one side will pull out of square, and a thin bracket welded too hot can bow. Most of the skill in steel welding is planning: tack order, weld order and letting the part cool in the right position.
How we handle steel in the shop
- 01
Prep the surface
Mill scale, oil and rust are ground or wiped away at the joint. Clean steel makes a smoother weld and a better base for paint.
- 02
Pick the process
Thicker parts and long seams usually go MIG. Thin or visible joints may go TIG. Some parts use both, and the quote says which.
- 03
Control distortion
We tack symmetrically, weld in short sections and alternate sides on frames. Clamps and the welding table hold the shape while it cools.
- 04
Ready for finish
Spatter is removed and sharp edges are broken. If your parts go to paint or powder coat, we leave them clean and dry for the next shop.
What to send for a quote
Fill in the form, then email these to [email protected]. The more we see, the fewer questions we need to ask.
Request a quote- Drawing, sketch or sample
- Steel shape and thickness: plate, bar, angle, tube or sheet
- Quantity and whether repeats are expected
- Finish plans, such as paint or powder coat
- Whether you supply the material or we source it
Questions
Steel welding questions
Answers we give most often about this kind of work.
Do you supply the steel or should we?
Either works. We can source common steel shapes, or you can send material or cut kits. The quote spells out which.
Can you weld galvanized or painted steel?
Coatings have to come off the weld area first. Tell us about any coating when you send the drawing so we can plan the prep.
Will the frame stay square?
We fixture, tack and sequence welds to keep frames as straight as we can, and we check them against your drawing before they leave.
Can you add parts to an existing steel assembly?
Yes, when the assembly fits through our door and the additions are brackets, guards, tabs or mounts. Send photos first.
What finish do steel parts leave with?
Clean, with spatter removed and edges broken. Grinding welds flush, painting or coating is quoted separately when you ask for it.
Send us the part for steel welding
Form first, then the drawing, sketch or photos by email. We review and reply with a written quote.

