04 / Material
Aluminum welding in Utah for covers, boxes and brackets
Aluminum is light and holds up well outdoors, but it welds very differently from steel. It carries heat away quickly, its oxide layer melts at a much higher temperature than the metal under it, and it gives little warning before it slumps. We treat it as its own job, with its own brushes, its own prep and usually TIG.

What aluminum welding looks like in our shop
Typical aluminum parts in our shop are covers and boxes for equipment, brackets for lights and sensors, small frames and plates with welded tabs. Many are sheet or thin plate, which is where careful heat control pays off.
Cleanliness decides the result. We remove oil with a solvent, brush off the oxide with a stainless brush kept only for aluminum and weld soon after cleaning. Skipping these steps is how aluminum welds end up dirty or porous.
Aluminum also asks for a little planning at the drawing stage. Joints that are easy to reach, edges that are not knife thin and corners with room for the torch all make a cleaner weld. When we review your part we point out any joint that would be hard to weld well and suggest a simple change, such as a small flange or a different corner, before anything is quoted.
How we handle aluminum in the shop
- 01
Separate tools
Aluminum gets its own brushes and files so steel particles never end up in the weld.
- 02
Degrease and brush
Oil comes off first, then the oxide layer is brushed away right before welding.
- 03
Manage the heat
Aluminum draws heat away fast, then suddenly softens. The welder starts with more heat, then eases off as the part warms, with short seams and planned breaks.
- 04
Leave it ready
Welds are brushed clean. If parts will be anodized or painted, tell us so we can plan filler choice and handling.
What to send for a quote
Fill in the form, then email these to [email protected]. The more we see, the fewer questions we need to ask.
Request a quote- Drawing, sketch or sample part
- Alloy, if known, and thickness
- Which welds are visible
- Quantity and any finish such as anodizing or paint
- Whether parts will be outdoors or indoors
Questions
Aluminum welding questions
Answers we give most often about this kind of work.
Do you MIG or TIG weld aluminum?
Mostly TIG, because it gives finer heat control on sheet and thin plate. Thicker parts may suit MIG; we explain the choice in the quote.
Can you weld cast aluminum parts?
Some castings weld well and some do not, depending on what they are made of and what they have soaked up in use. Send photos and we will be honest about what we can do.
Will the welds match the color after anodizing?
Welds can look slightly different after anodizing. Tell us if the part will be anodized, so we can choose filler with that in mind.
Why is aluminum work quoted differently from steel?
Extra cleaning, slower welding and more careful handling. The quote shows the steps for your part.
Is thin aluminum sheet something you weld?
Yes, with TIG, tight fit-up and short welds. Very thin sheet takes care, and we may suggest a joint design that makes it easier.
Send us the part for aluminum welding
Form first, then the drawing, sketch or photos by email. We review and reply with a written quote.

