How a job runs
How a welding job runs in Utah
Six stages, the same for a single prototype or a run of matching parts. You always know what happens next, and nothing is cut until you approve the quote.
- 01
Drawing or sample
Send what you have: a drawing, a sketch with dimensions, photos or a sample part. Email files after the form so we can see the details.
- A PDF or CAD export, or a hand sketch with dimensions
- Photos with a tape measure in frame are useful
- A sample part can be dropped off during shop hours
- Tell us the quantity and finish you have in mind
- 02
Review and questions
We go through the drawing or sample, check material and thickness, and look at each joint. If something is unclear, we ask before we quote.
- Material, thickness and joint types checked
- MIG, TIG or both chosen for each joint
- Small design tweaks suggested only when they help welding
- Questions sent by email or a short call
- 03
Written quote
You get the scope in writing before any work starts: material, process, quantity, finish and what we need from you.
- Who supplies material: you or us
- Finish called out: as welded, blended or brushed
- First article noted if the job is a run
- Nothing starts until you approve it
- 04
Cut, prep and fit-up
Stock is cut and cleaned, edges are prepared and pieces are fitted and tacked on the table or in a jig.
- Joints cleaned of oil, scale and oxide
- Parts squared and tacked in sequence
- A jig built for batches so parts match
- Fit checked against the drawing before welding
- 05
Weld and finish
The main welds go down in a planned order to keep the part straight. Spatter is removed and the finish is done as quoted.
- Settings matched to the material and thickness
- Welds sequenced to limit distortion
- Spatter cleaned, edges broken
- Finish done as written in the quote
- 06
First article and pickup
For runs, the first part is set aside for you to look over. Finished parts are ready for pickup at the shop during weekday hours.
- First article shown before the full run
- Parts counted and bagged or bundled
- Pickup at the shop on weekdays
- Notes kept for any repeat run

Why the first article matters
On any run, the first finished part is set aside for you. You can hold it, fit it to your equipment and check it against the drawing before we make the rest. A small change at this point costs far less time than finding it after fifty parts.
Sending files and samples
The form on our contact page has no upload button on purpose. Send the request first, then email drawings, sketches or photos to [email protected] with your company name in the subject line, and we match them to your request. Larger samples can be dropped off at the shop during weekday hours; call ahead so someone can look at the part with you.
If your drawing has a revision letter, include it. If the part has to mate with something you are not sending, give us the critical dimensions and tell us which faces matter. Clear notes at the start save a round of questions later.
Questions
What people ask about the process
What businesses ask us about scheduling, drop-off and changes.
How soon can you start?
It depends on what is already on the table. Once we review your drawing, we give you a realistic schedule in the quote rather than a promise up front.
Can we drop off parts or samples?
Yes, during weekday shop hours. Call or email first so someone is ready to look at it with you.
Do you weld outside the shop?
All of our work is done in the shop, where we have the tables, fixtures and steady conditions that clean welds need.
What if the first part needs a change?
That is what the first article is for. Tell us what to change, we update the drawing notes and the quote if needed, and then run the rest.
Are our drawings kept private?
Yes. Drawings and samples are used only to quote and build your parts.
Ready for stage one?
Send the form and then the drawing by email. We take it from there and keep you posted at each stage.