01 / Process
MIG welding in Utah for parts and small runs
MIG is the workhorse of our shop. A wire electrode feeds through the torch while a shielding gas protects the puddle, so the welder can lay long, steady beads on steel parts without stopping to change rods. For brackets, mounts, equipment frames and small batches, it is usually the process that gets clean, consistent welds onto the table quickly.

What MIG welding looks like in our shop
Most of the MIG work that comes through our door is mild steel between thin sheet and medium plate: machine guards, fixture bases, tube frames for equipment, tabs and gussets, and parts that a manufacturer needs in a run of ten or fifty rather than one. MIG lets us keep the same settings across a batch, so the fifth part looks like the first.
Because the wire feeds continuously, MIG is forgiving on long seams and fillet welds. It also handles mill scale and light surface rust better than TIG, which matters for parts cut from bar stock and tube. We still clean every joint before welding, but the process gives us a wider window on everyday steel.
How we run a MIG job
- 01
Set the joint first
We cut, deburr and fit the pieces, then tack them square on the table. Good fit-up is what keeps a MIG bead even, so we spend time here before any long weld goes down.
- 02
Dial the settings to the part
Wire speed and voltage change with metal thickness and joint type. Thin brackets get a cooler, quicker setting; thicker plate gets more heat for proper fusion. That is the idea behind the bead simulator on our home page.
- 03
Sequence the welds
On frames and long seams, we weld in a planned order and alternate sides so the part stays as straight as possible while it cools.
- 04
Clean up and check
Spatter is removed, edges are knocked down where needed and the part is checked against your drawing before it goes back to you.
What to send for a quote
Fill in the form, then email these to [email protected]. The more we see, the fewer questions we need to ask.
Request a quote- A drawing, sketch or a sample part
- Material and thickness, if you know them
- Quantity: one piece, a small batch or a repeat run
- Which faces are visible and which are hidden
- Any finish that follows, such as paint or powder coat
Questions
MIG welding questions
Answers we give most often about this kind of work.
When is MIG a better choice than TIG?
For steel parts of everyday thickness, long seams and batches where steady output matters. TIG gives finer control on thin or visible joints, but MIG is faster on most brackets, frames and mounts.
How do you MIG weld thin sheet without distortion?
Often, yes. We use a cooler setting, short stitch welds and a planned sequence. On very thin or cosmetic sheet parts we may suggest TIG instead, and we will tell you why before quoting.
Do you weld parts that others have cut?
Yes. If you send cut blanks or kits, we can fit and weld them. Tell us how they were cut so we know what edge prep to expect.
Can you make a part to match one I have?
Bring or ship us a sample. We review it, measure it and quote the copy in writing before any work starts.
Do you grind welds flush?
When the drawing calls for it. Many brackets and frames leave the weld as is; visible faces can be blended. We note the finish in the quote.
Send us the part for MIG welding
Form first, then the drawing, sketch or photos by email. We review and reply with a written quote.

